Mueller CF Panel User Manual download pdf (Page 26)

The uphill flashing will be 4” wider than the width of the

curb (2” on each side). Cut an 1/8” slot in the two uphill

corners of the panel slightly wider than 2 1/16”, so the

uphill flashing can slide through the two slots.

CHIMNEY INSTALLATION

Details are subject to change without prior notice.

CHIMNEY FLASHING - UPHILL AND DOWNHILL

1. Trim both ends of the uphill and downhill sides of the

flashing as indicated.

2. Slide the uphill flashing into the slots of the roofing and

apply liberal amount of tube caulk.

NOTE: Alternate trim profiles are acceptable using the screw pattern shown.

DOWNHILL

UPHILL

NOTE: To comply with Texas Windstorm Certification Testing, #12x11

SDT Type A screws must be used in place of the #9 Woodgrip screws.

1 2 ... 21 22 23 24 25 26 27 28

No comments

Mueller CF Panel User Manual Page 26